America's #1 Direct Source for Pool Supplies!

1.800.288.7946 Experts Available 24/7

Call Cart
one day delivery

1 Day Delivery

Your ZIP Code: 06828 Fairfield Change Location

To Fairfield Change
Celebrating 35+ Years!
Source / Promo Code:WYAARUNKEdit
cart overlay

    Showing 0 of 0 item View All

    Estimated SUBTOTAL* :  $0.00

    *Excludes taxes, handling fee, and EZ Pay Service Fee, if applicable.
    Source Code:WYAARUNK Edit

    AquaBot Pool Rover T Robotic Pool Cleaner

    Item # E1595
    Out of Stock

    Harness the Cleaning Power of the AquaBot Pool Rover T

    The Pool Rover T robotic pool cleaner is an easy-to-use, lightweight machine that can clean a 24-foot found above ground swimming pool in less than an hour. The robotic pool vacuum replaces the need of clumsy hand-held vacs attached to extension poles, and allows you to sit back and relax while it does all the work. A self-contained filtration system keeps your pool filter free from anything sucked up, and the top loading, easy to empty EZ clean bags grab particles down to 2 microns in size.

    • AquaBot Pool Rover T methodically cleans rectangular, round and oval pools
    • The robotic cleaner is pre-programmed to clean every inch of your pool methodically and automatically
    • Wide chassis and non-marring polyethylene wheels allow Pool Rover T robotic pool cleaner to roll over rippled or “foot-printed” vinyl pool bottoms
    • Filters 4,800 gallons per hour, using build-in filter and easy-to-empty filter bags
    • Collects debris of all sizes, from leaves to algae
    • Doesn’t use any hoses; leaves your pool filter free to keep running
    • Employs 1 or 2 hour auto shut off
    • Plugs into standard outlet; uses included 40 ft. power cord

    • Customer Review
    • Product Specification

    Recommended Pool Size Above-Ground Vinyl Liner Pools up to 20 ft. x 50 ft.
    Cleaning Coverage Up to 5000 feet per hour
    Filtration Quantity 4800 gallons per hour
    Filtration Capability Down to 2 microns
    Filtration Intake 2 intake valves, 1 in. x 4.5 in. each
    Filtration Capacity Reusable, cleanable filter bag is 4 sq. ft. capacity
    Cable 51 ft. with floating buoys
    Electrical Specifications
    Transformer: 110 Vac to 12Ah @ 30 Vac
    Pump Motor: 150 watt 28 Vac - Oil Filled
    Programmable Cleaning Pattern Adjustable, precision scanning via HydroJet Directional Guidance System (patent pending)
    Propulsion Jet Drive Propulsion System (JDPS) -- same principle as used in a jet ski
    Unit Weight: 11 pounds
    Voltage: 24v

    Does not pump water, move or vacuum.

    • Check to see if electric outlet has power.
    • Check to see if the Power Supply is plugged into a grounded outlet and that the floating cable is plugged into the Power Supply.
    • Check the Fuse in the Power Supply. If necessary replace the fuse. (Replacement fuses are available at electronic and hardware stores.)
    • Check cables for possible cuts or damage.

    Does not vacuum well or at all.

    • Check to see if the filter bag is thoroughly clean.
    • Check to see if the Intake Valve Flaps on the bottom of the cleaner are free to open and close. These flaps should move easily to allow the entry of water and debris.

    **NOTE: Use the Fine Filter bad to trap smaller debris such as algae, bacteria, sand and silt. Use the Mesh Filter bag to trap larger debris such as leaves, acorns, twigs, and pine needles.
    Does not cover the entire pool.

    • Check to see if the wheel movement is free of obstructions like hair, string or accumulated debris.
    • Check to see if the Filter Bag is clean and not clogged with debris.
    • Adjust timing cycle so that the POOL ROVER reaches the other side of the pool before changing direction.

    Does not reverse direction.

    • While the POOL ROVER is running, gently lift it partially out of the water by the handle so that the Jet Valve Housing is above water level and hold it for approximately two seconds. Then lower the unit so that the Jet Valve Housing is below water level for approximately five seconds. Repeat this procedure until a jet stream is produced alternately at each side.
    • Take a garden hose and, with the pressure set on “high”, spray it into the valve housing at each opening. This should free the Jet Valve System of any debris. If this does not solve the problem, there is most likely debris wrapped around the impeller beneath the Jet Valve.

    Reverses before reaching the opposite end of the pool.

    • Turn the Time Control Knob (located on the Power Supply) clockwise a few degrees to increase the time between reversals. Repeat if necessary.

    Waits too long at the side of the pool before reversing.

    • Turn the Time Control Knob on the Power Supply counter-clockwise a few degrees. Repeat if necessary.

    Floating cable is twisting.

    • Your POOL ROVER pool cleaner was designed to clean most above-ground pools. Some pool shapes may cause the power cord to coil, or tangle because the cleaner operates in a systematic pattern that is circular in nature. This may cause the power cord to twist. A new patented feature that allows you to easily untwist your cord.
    • Place you cleaner on the ground outside of the pool. Locate the plastic handle near the power supply connection plug. Grab the handle firmly. Walk away from the cleaner while pulling the handle. The cable will rotate within the plastic handle and force the cord to untwist itself. For best results remember to pull the handle until the cord is completely untwisted.

    Product Downloads